Outback VDC Wagon AWD F6-3.0L (2002)
8. Position woodruff key in groove on the rear of driven shaft. install 5th driven gear onto drive shaft using ST and press.
CAUTION: Do not apply/pressure in excess of 10 kN (1 ton, 1.1 US ton ,10 Imp ton).
ST 499277200 INSTALLER
9. Install lock washer. Install lock nut and tighten to the specified torque using ST. ST 499987300 SOCKET WRENCH (50)
Tightening torque: 265 Nm (27 kgf-cm, 195 ft. lbs.)
NOTE:
^
Stake lock nut at two points.
^
Using spring balancer, check that starting torque of roller bearing is 0.1 to 1.5 N (0.01 to 0.15 kgf, 0.02 to 0.33 lbs.).
10. Install roller bearing onto drive pinion.
NOTE: When installing roller bearing, note its directions (front and rear) because knock pin hole in outer race is offset.
