SVX FWD L6-3.3L DOHC (1994)
13. Removal of snap ring from seal holder assy While attaching small screwdriver blade to snap ring via groove on boot (on cylinder side of steering
body assy), push the snap ring using another screwdriver
14. Removal of rack assy Push rack out of steering body assy while pushing it on valve side.
a. Block pipe connection of steering body assy to prevent fluid from flowing out.
b. Do not allow rack to come in contact with inner wall of cylinder. Otherwise, cylinder wall may be scratched, resulting in oil leaks.
c. Remove holder assy and rack assy as a unit.
d. Check rack and steering body assy for bends or cracks; replace as required.
15. Removal of high-pressure seal Insert REMOVER from valve side, and lightly tap it using a hammer to drive out back-up ring and oil seal. Discard
back-up ring and oil seal after removal; replace with new ones.
16. Removal of oil seal and O-ring
a. Using a small rod, pry out oil seal.
NOTE: Be careful not to scratch oil seal groove on holder assy. A scratch may cause oil leaks. Be careful not to scratch mating surfaces of holder
assy and racy A scratch may cause oil leaks. Check rack bushing for wear or damage; replace as required. Discard oil seal and O-ring after
removal; replace with new ones.
b. Remove O-ring.
c. Apply a coat of grease to oil seal groove in holder assy.
