SVX LSi AWD L6-3.3L DOHC (1997)
b. Install retaining ring on oil seal. Using GUIDE, press shaft and bearing assy into front body. a. Be careful not to strike shaft splices on oil seal's
sealing lips during installation. b. Do not hit end of shaft during installation.
c. Lock drive shaft using a retaining ring.
3. Installation of pressure plate: Place front body in a vise with pulley side facing down. Position two O-rings and pressure plate in front body in that
order. Do not forget to install O-rings.
4. Installation of cartridge
a. Install cam, rotor and vane in that order.
b. Insert pin into holes in cam and pressure plate.
NOTE: Ensure that vane is installed with "R" side facing the cam. Check that vane moves smoothly. Apply a coat of automatic transmission fluid
(DEXRON II) to vane.
5. Installation of rear body
a. While aligning pin hole of rear body with pin on the pump, install rear body using a gasket and tighten bolts by hand.
b. Remove pump from vise.
c. Place pump bracket in a vise, install pump on pump bracket.
d. Tighten rear body mounting bolts in a cries-cross fashion to one-half of specified torque, then tighten to specified torque. After tightening rear
body mounting bolts, ensure that shaft rotates properly.
6. Installation of valve
a. Position spring and valve assy in front body in that order.
b. Connect connector to front body with an O-ring in place. Tightening torque: 29-39 Nm (22-29 ft. lbs.).