Tribeca F6-3.6L (2008)
Intake Manifold: Overhaul
DISASSEMBLY
1. Remove the engine harness from intake manifold.
2. Remove the throttle body.
3. Remove the manifold absolute pressure sensor.
4. Remove the purge control solenoid valve.
5. Loosen the clamp which holds fuel injector pipe to the fuel hose, and then disconnect the pipe from fuel hose.
6. Remove the bolts which install fuel pipes on intake manifold.
7. Remove the EGR valve.
ASSEMBLY
NOTE: When assembling the nipple, apply liquid gasket.
Liquid gasket: THREE BOND 1105 (Part No. 004403010) or equivalent
Tightening torque: 17 N.m (1.7 kgf.m, 12.5 ft.lb)
1. Install the EGR valve.
2. Tighten the bolts which install fuel pipes on intake manifold.
Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)