Tribeca F6-3.6L (2008)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor
Fuel Level Sensor
REMOVAL
WARNING: Place "NO FIRE" signs near the working area.
CAUTION:
-
Be careful not to spill fuel.
-
When the fuel meter indication is higher than two third of the total, perform the work after draining the fuel not to spill the fuel.
NOTE: The fuel level sensor is built in fuel pump assembly.
1. Remove the fuel pump assembly.
2. Disconnect the connector (A) from fuel pump bracket.
3. Remove the fuel temperature sensor (B).
4. Remove the fuel level sensor (C).
INSTALLATION
1. Install the fuel level sensor (C).
2. Install the fuel temperature sensor (B).
3. Connect the connector (A) to fuel pump bracket.
4. Install the fuel pump assembly.