Tribeca F6-3.6L (2008)
Fuel Gauge Sender: Service and Repair
Fuel Sub Level Sensor
Fuel Sub Level Sensor
REMOVAL
WARNING: Place "NO FIRE" signs near the working area.
CAUTION:
-
Be careful not to spill fuel.
-
When the fuel meter indication is higher than two third of the total, perform the work after draining the fuel not to spill the fuel.
1. Release the fuel pressure.
2. Drain fuel.
3. Remove the second seat.
4. Remove the service hole cover.
5. Disconnect the connector from the fuel sub level sensor.
6. Disconnect the quick connector, and then disconnect the fuel delivery hose and jet pump hose.
7. Remove the nuts and bolts which install fuel sub level sensor on fuel tank.
8. Remove the fuel sub level sensor.
INSTALLATION
Install in the reverse order of removal while being careful of the following.