Tribeca F6-3.6L (2008)
Alternator: Overhaul
Generator
DISASSEMBLY
1. Remove the four through-bolts.
2. Heat the portion (A) of rear cover to 50 °C (122 °F) with a heater drier.
3. Then insert the tip of a flat tip screwdriver into the gap between stator core and front cover. Pry them apart to disassemble.
4. Hold the rotor with a vise and remove pulley nut.
CAUTION: When holding the rotor with a vise, place aluminum plates or wooden pieces on the vise jaws to prevent rotor from damage.