Aerio L4-2.3L (2006)
2. Connect driver air bag (inflator) module connectors (1) (orange) and (2) (black) to driver air bag (inflator) module (3) securely as shown in the
figure.
a. Connect connectors.
b. Lock connectors with lock button.
3. Install driver air bag (inflator) module (1) to steering wheel (2), taking care so that no part of wire harness is caught between them.
4. Make sure that clearance between module (1) and steering wheel (2) is uniform all the way.
5. Tighten driver air bag (inflator) module mounting bolt (left side) (3) to specified torque first and then driver air bag (inflator) module mounting
bolt (right side) (4) to specified torque.
Tightening torque
Driver air bag (inflator) module mounting bolt a: 9 N.m (0.9 kg-m, 6.5 lb-ft)
6. Enable air bag system. Refer to Enabling Air Bag System:Advanced Air Bag.
7. Connect negative cable at battery.
Passenger Air Bag (Inflator) Module
Passenger Air Bag (Inflator) Module Removal and Installation
WARNING:
-
Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality is found, be sure to replace it with new
one as an assembly.
-
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag, Precautions on Handling and Storage of Air
Bag System Components:Advanced Air Bag and Precautions on Disposal of Air Bag and Seat Belt Pretensioner:Advanced Air Bag before
starting to work and observe every precaution during work. Neglecting them may result in personal injury or undeployment of the air
bag when necessary.
Removal
1. Disable air bag system. Refer to Disabling Air Bag System:Advanced Air Bag.
2. Remove blower unit and fresh air inlet duct referring to Blower Unit Removal and Installation.