Aerio L4-2.3L (2006)
2. Connect connector (1) of driver air bag (inflator) module (3) securely as shown in the figure.
a. Connect connector.
b. Lock connector with lock button.
3. Install driver air bag (inflator) module (3) to steering wheel (4), taking care so that no part of wire harness is caught between them.
4. Make sure that clearance between module (3) and steering wheel (4) is uniform all the way.
5. Tighten driver air bag (inflator) module mounting bolt (left side) (5) to specified torque first and then driver air bag (inflator) module mounting
bolt (right side) (6) to specified torque. Tightening torque
Driver air bag (inflator) module mounting bolt a: 9 N.m (0.9 kg-m, 6.5 lb-ft)
6. Connect negative battery cable.
7. Enable air bag system. Refer to Enabling Air Bag System:Except Advanced Air Bag.
Passenger Air Bag (Inflator) Module
Passenger Air Bag (Inflator) Module Removal and Installation
WARNING:
-
Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality is found, be sure to replace it with new
one as an assembly.
-
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Except Advanced Air Bag before starting to work and observe
every precaution during work. Neglecting them may result in personal injury or undeployment of the air bag when necessary.
Removal
1. Disable air bag system. Refer to Disabling Air Bag System:Except Advanced Air Bag.
2. Remove blower unit and fresh air inlet duct referring to Blower Unit Removal and Installation.
