Aerio L4-23L (2006) Air Bag Control Module Service and Repair
Air Bag Control Module: Service and Repair
With Advanced Air Bag
SDM
SDM Removal and Installation
WARNING:
During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM).
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag before starting to work and observe every
precaution during work. Neglecting them may result in personal injury or inactivation of the air bag system when necessary.
Removal
1. Disconnect negative cable at battery.
2. Disable air bag system referring to Disabling Air Bag System:Advanced Air Bag.
3. Remove center console box upper cover.
4. Disconnect SDM connector (2) from SDM (3).
5. Remove SDM (3) from vehicle.
Installation