Aerio L4-2.3L (2006)
2. Install piston assembly (1) into cylinder. When inserting it, be careful not to cause damage to lip of piston cup (2).
3. Install boot and push rod.
Inspection
Inspect all disassembled parts for wear or damage, and replace parts if necessary.
NOTE:
^
Wash disassembled parts with brake fluid.
^
Do not reuse piston assembly.
Inspect cylinder bore for scoring or corrosion.
It is best to replace corroded cylinder. Corrosion can be identified as pits or excessive roughness.
NOTE: Polishing bore of cylinder with anything abrasive is prohibited, as damage to cylinder bore may occur.
Rinse cylinder in clean brake fluid. Shake excess rinsing fluid from cylinder. Do not use a cloth to dry cylinder, as lint from cloth cannot be kept away
from cylinder bore surfaces.
Clutch Operating Cylinder Removal and Installation
Clutch Operating Cylinder Removal and Installation
Removal
NOTE: Do not allow fluid to get on painted surfaces.
1. Clean around master cylinder reservoir cap and take out fluid with syringe or such.
