Aerio L4-2.3L (2006)
2. Disconnect fluid hose (5) from operating cylinder by loosing union bolt (4).
3. Remove operating cylinder attaching bolts (2) and operating cylinder assembly (1).
Installation
For air bleeding of master cylinder alone, it must be removed from vehicle body.
1. Apply small amount of grease to rod tip.
NOTE: Don't allow any grease to be on boot.
"A": Grease 99000-25010
2. Install clutch operating cylinder assembly (1) and tighten attaching bolts (2) to specified torque.
Tightening torque
Operating cylinder attaching bolts (a): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)
