Workshop Repair Manuals

Suzuki Workshop Manuals

[PREV PAGE] [NEXT PAGE]

suzuki Workshop Repair Guides


Equator 2WD V6-4.0L (2009)

Heating and Air Conditioning > Refrigerant Oil > Component Information > Specifications > Page 4104

Page 2
background image

1. Before connecting recovery/recycling equipment to vehicle, check recovery/recycling equipment gauges. No refrigerant pressure should be

displayed. If NG, recover refrigerant from equipment lines.

2. Connect recovery/recycling equipment to vehicle. Confirm refrigerant purity in supply tank using recovery/recycling equipment and refrigerant

identifier. If NG, refer to [Precautions: Contaminated Refrigerant].

3. Confirm refrigerant purity in vehicle A/C system using recovery/recycling equipment and refrigerant identifier. If NG, refer to [Precautions:

Contaminated Refrigerant].

4. Discharge refrigerant into the refrigerant recovery/recycling equipment. Measure oil discharged into the recovery/recycling equipment.
5. Drain the oil from the "old" (removed) compressor into a graduated container and recover the amount of oil drained.
6. Drain the oil from the "new" compressor into a separate, clean container.
7. Measure an amount of new oil installed equal to amount drained from "old" compressor. Add this oil to "new" compressor through the suction port

opening.

8. Measure an amount of new oil equal to the amount recovered during discharging. Add this oil to "new" compressor through the suction port

opening.

9. If the liquid tank also needs to be replaced, add an additional 5 ml (0.2 US fl oz, 0.2 Imp fl oz) of oil at this time. Do not add this 5 ml (0.2 US fl

oz, 0.2 Imp fl oz) of oil if only replacing the compressor.

Heating and Air Conditioning > Refrigerant Oil > Component Information > Specifications > Page 4104

[PREV PAGE] [NEXT PAGE]