Equator 2WD V6-4.0L (2009)
Side Air Bag: Service and Repair
Side Curtain Air Bag Module: Removal And Installation
Side Curtain Air Bag Module
REMOVAL
CAUTION:
-
Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a direct-connect harness connector is
damaged, the harness must be replaced.
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
-
When servicing the SRS, do not work from directly in front of air bag module.
1. Remove headlining.
2. Disconnect front and rear side curtain air bag module connectors.
-
For removal/installation of the direct-connect SRS connectors, refer to [Direct-connect SRS Component Connectors Description].
3. Remove the bolts in order starting at the front or rear, and remove the side curtain air bag module.
CAUTION:
-
When servicing the SRS, do not work from directly in front of air bag module.
-
Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
-
Do not disassemble air bag module.
-
Do not expose the air bag module to temperatures exceeding 90°C (194°F).
-
Replace side curtain air bag module if it has been dropped or sustained an impact.
