Forenza L4-2.0L (2004)
Fluid - A/T: Service and Repair
Fluid Level Set After Service
Fluid Level Set after Service
1. Add transaxle fluid through the fill cap hole prior to adjusting the fluid level. The amount of fluid to add should be based on the type of service
done.
Adjustment Notice
^
Use ESSO LT 71141 or TOTAL ATF H50235 transaxle fluid only.
^
Oil pan removed: 4 Liters (4.2 quarts)
^
Torque converter removed: 2 Liters (2.1 quarts)
^
Complete overhaul: 6.9 ± 0.2 Liters (7.3 ± 0.2 quarts)
^
Drain plug removed: 4 Liters (4.2 quarts)
2. Check the transaxle fluid level.
3. Add additional fluid through the fill cap hole in 0.5 Liters (0.5 quarts) increments until the fluid comes out through the plug hole.
4. Allow the fluid to finish draining out through the plug hole, then install the fluid level plug.
5. When the fluid level setting procedure is completed, wipe any fluid from the transaxle case with a rag or shop towel. Also, check that the fluid fill
cap and the vent tube are properly installed.
