Grand Vitara 2WD V6-2.7L (2006)
4) Install connecting rod bearing cap (1) as follows.
NOTE: If connecting rod bolt is reused, mark sure to check connecting rod bolt for deformation, referring to "Connecting Rod Bolt Deformation
(Plastic Deformation Tightening Bolt)" under Crank Pins and Connecting Rod Bearings Inspection.
a) Point arrow mark (2) on cap to crankshaft pulley side.
b) Apply engine oil to new connecting rod bolts (3).
c) Tighten all connecting rod bolts to 15 Nm (1.5 kgf-m, 11.0 ft. lbs.).
d) Retighten them by turning through 45°
e) Repeat step d) once again.
5) Install cylinder heads to cylinder block.
6) Install oil pump to cylinder block.
7) Install tappets, shims and camshafts.
8) Install RH (No.2) bank 2nd timing chain, referring to RH (No.2) Bank 2nd Timing Chain and Chain Tensioner Removal and Installation.
9) Install 1st timing chain.
10) Install LH (No.1) bank 2nd timing chain.
11) Install timing chain cover.
12) Install oil pans and pump strainer.
13) Install cylinder head covers.
14) Install exhaust manifold.
15) Install radiator outlet pipe.
Refer to Cooling Water Pipes or Hoses Removal and Installation.
16) Install intake manifold, intake collector and electric throttle body assembly, referring to Intake Collector and Intake Manifold Removal and
Installation and Electric Throttle Body Assembly Removal and Installation.
17) Install engine assembly to vehicle.
