Front Suspension Cross-Member Service and Repair - Page 3994
3. Install rear suspension frame (3) to vehicle body and tighten rear suspension frame mount bolts (1) with washer (2) to specified torque.
CAUTION: If reuse suspension frame mount bolt, apply engine oil to thread, bearing and trunk surface.
Tightening torque
Rear suspension frame mount bolt a: 135 Nm (13.5 kg-m, 98.0 ft. lbs.)
4. Tighten wheel sensor bolt (1) to specified torque and then connect wheel sensor harness clamp (2).
Tightening torque
Wheel sensor bolt a: 11 Nm (1.1 kg-m, 8.0 ft. lbs.)
5. Tighten parking cable clamp bolt (1) to specified torque and then connect parking cable clamp (2).
Tightening torque
Parking cable clamp bolt a: 25 Nm (2.5 kg-m, 18.0 ft. lbs.)
