Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor
Type 1
OUTPUT VOLTAGE INSPECTION
Check in the same procedure as that used of front wheel speed sensor check.
Output AC voltage at 2/3 to one rotation per second (25 - 38 Hz): 100 mV or more
Reference
When using oscilloscope, peak-to-peak voltage at 2/3 to one rotation per second (25 - 38 Hz): 150 mV or more
REMOVAL
1. Disconnect negative cable from battery.
2. Hoist vehicle.
3. Disconnect rear wheel speed sensor connector and detach wire harness from vehicle body and rear axle.
4. Remove harness clamps and remove rear wheel speed sensor from rear axle.
CAUTION:
^
Do not pull wire harness when removing rear wheel speed sensor.
^
Do not cause damage to surface of rear wheel speed sensor and do not allow dust, etc. to enter its installation hole.