Grand Vitara LTD 2WD V6-2.5L (2001)
4. Remove harness clamps (2) and remove rear wheel speed sensor from rear axle.
CAUTION:
^
Do not pull wire harness when removing rear wheel speed sensor.
^
Do not cause damage to surface of rear wheel speed sensor and do not allow dust, etc. to enter its installation hole.
INSPECTION
Sensor
^
Check sensor (pole piece) for damage or bent. If any faulty is found, replace.
^
Check sensor for resistance. If any faulty is found, replace.
Resistance between terminals of wheel speed sensor: 0.8 - 1.6 k Ohms at 20°C (68°F)
Resistance between terminal and wheel speed sensor body: 1 M Ohms or more
Sensor Rotor
^
Check rotor serration (teeth) for being missing, damaged or deformed.
^
Turn wheel and check if rotor rotation is free from eccentricity and looseness.
^
Check that no foreign material is attached. If any faulty is found, repair or replace.
INSTALLATION
1. Check that no foreign material is attached to sensor and rotor.