Kizashi AWD L4-2.4L (2010)
air bag.
Special Tool
(A): 09932-75031
-
Never attempt to insert foreign matter such as flat head screwdriver into connectors of air bag (inflator) module and seat belt pretensioner as static
electricity may cause accidental deployment.
Deployment / Activation Outside of Vehicle
CAUTION:
-
Since smoke is produced when air bag (inflator) module is deployed and pretensioner is activated, select well-ventilated area.
-
Wear safety glasses during this deployment / activation procedure.
-
Check that there is no open, short or damage in special tools (deployment harness and adapter cable).
Removal
Remove air bag (inflator) module or seat belt pretensioner from vehicle.
-
Driver air bag (inflator) module
-
Passenger air bag (inflator) module
-
Retractor pretensioner (inflator) module
-
Lap pretensioner (inflator) module
-
Front side air bag (inflator) module
-
Rear side air bag (inflator) module
-
Curtain air bag (inflator) module
Setting
Driver Air Bag (Inflator) Module
1. Clear space (3) on ground about 185 cm (6 ft) in diameter where driver air bag (inflator) module (1) is set for deployment. Paved and outdoor
location where there is no activity preferred. If outdoor location is not available, use space on shop floor where there is no activity and sufficient
ventilation is provided.
Ensure no loose or flammable object exists within deployment area.
2. Place driver air bag (inflator) module (1) with its vinyl trim cover facing up (2) on ground Step 1).