Kizashi AWD L4-2.4L (2010)
12) Remove drive shaft assembly.
Installation
CAUTION:
^
Be careful not to damage oil seals and boots when installing drive shaft.
^
Do not hit joint boot with hammer.
Insert joints by hand only.
^
Make sure differential side joint is inserted fully and its circlip is seated as it was.
Install drive shaft assembly by reversing removal procedure noting the following points:
^
Use new differential side joint circlip.
^
Tighten strut bracket bolts and new nuts to specified torque.
^
Tighten front stabilizer bar joint nut to specified torque.
^
Tighten front wheel speed sensor bolt to specified torque.
^
Tighten front brake caliper bolts to specified torque.
^
Tighten new drive shaft nut to specified torque, loosen it one rotation or more, and then retighten it to specified torque.