Swift L4-1298cc 1.3L SOHC MFI (1997)
4. Disconnect brake hose bracket from knuckle.
5. For vehicles equipped with ABS: Disconnect coupler of ABS rear wheel sensor.
6. Disconnect brake pipe from wheel cylinder and put wheel cylinder bleeder plug cap onto pipe to prevent fluid from spilling.
7. Remove brake back plate from knuckle.
8. Place jack under suspension arm so as to prevent it from lowering.
9. Remove nut and washer from inside (body center side) of control rod. As preparatory step of this removal, check stamped line on washer to use for
guide in reinstallation.
10. Remove outside (wheel side) of control rod from rear knuckle stud bolt.
11. Remove strut lower mount bolt.