Swift L4-1298cc 1.3L SOHC MFI (1997)
3. Remove spring seat snap ring. Compress piston return springs by using special tool and then remove snap ring
Special Tool (A): 09926-98310 or equivalent.
CAUTION: Do not compress spring seat too much. Excessive compression may cause to spring seat to become distorted.
4. Remove spring seat and return spring assembly.
5. Remove direct clutch piston. Blow compressed air through drum oil hole to remove piston. If piston does not pop out, take out piston with long
nose pliers.
6. Remove inner seal from drum.
7. Remove outer seal from piston.
INSPECTION
1. Check valve (steel ball) for free movement in piston.
2. Check valve for leakage by using low pressure air. If found faulty, replace piston.
INSTALLATION
1. Install inner seal (O-ring). Apply transmission fluid to inner seal and fit it in drum. Use new inner seal.