Swift L4-1298cc 1.3L SOHC MFI (1997)
3. Remove seat snap ring. Compress piston return springs and remove snap ring. Place special tool (clutch spring compressor) on spring seat and
compress spring with a press, and then, remove snap ring, using a screwdriver.
Special Tool (A): 09926-98310 or equivalent.
CAUTION: Do not push down return spring more than necessary.
4. Remove spring seat and springs.
5. Remove forward clutch piston. Blow compressed air through input shaft oil hole to remove piston. If piston does not pop out, take it out with long
nose pliers.
6. Remove inner and outer seals (O-rings) from piston.
INSPECTION
1. Check valve (ball) for free movement in clutch piston.
2. Check valve for leakage by using low pressure air. If found faulty, replace clutch piston.
INSTALLATION
1. Install inner and outer seals (O-rings) to clutch piston. Apply transmission fluid to them and fit to piston. Use new seals.
2. Install piston into input shaft drum. Use care so that seals do not get twisted or caught.
3. Install 18 piston return springs and spring seat.