Swift L4-1298cc 1.3L SOHC MFI (1997)
4. Install spring seat snap ring. Compress return springs and install snap rings in groove by using a screwdriver. Place special tool (clutch spring
compressor) on spring seat and compress springs with a press.
Special Tool (A): 09926-98310 or equivalent.
CAUTION:
^
Check to make sure that snap ring is securely fitted in four projections of spring seat.
^
Do not compress return spring more than necessary.
5. Install discs, plates and flange in following order: (1)Plate->(2)Disc->(3)Plate->(4)Disc-> (5)Plate->(6)Disc->(7)Flange.
NOTE: Before assembly, new discs should be soaked in automatic transmission fluid for two hours or more.
6. Install clutch plate snap ring.
7. After installing clutch plate snap ring, measure height between snap ring and clutch flange as previously outlined. If discs and plates are new and
yet out of specification, install flange of different thickness. Following two types of clutch flanges are available as spare parts.
Height "a": 2.01 - 2.68 mm (0.079 - 0.105 inch).
Available clutch flange size:
Thickness: 3.00 mm/O.118 inch).