Swift GA L4-1298cc 1.3L SOHC MFI (2001)
NOTE: Left figure shows ratchet position where brake shoe-to-drum clearance is maximum.
2. Put brake shoe lever stopper back to its original position. (Put shoe lever stopper in place by moving shoe lever so that shoe lever is held at its
original position.)
3. Install brake drum after making sure that inside of brake drum and brake shoes are free from dirt and oil.
4. Tighten brake drum screws.
5. Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs.) load three to five times so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable.
6. Install parking brake lever cover.
7. Install wheel and tighten wheel nuts to specified torque.
Tightening Torque (a): 65 Nm (6.5 kg-m, 47.0 ft. lbs.)
8. Check to ensure that brake drum is free from dragging and proper braking is obtained. Then remove vehicle from hoist and perform brake test
(foot brake and parking brake).