Swift GA L4-1298cc 1.3L SOHC MFI (2001)
4. Remove oil seal and install a new one until it becomes flush with case surface by using special tool and hammer.
NOTE: When installing oil seal, face its spring side inward.
Special Tool
(A): 09913-75510 (for LH and RH)
5. Apply grease to oil seal lip and at the same time check drive shaft where oil seal contacts and make sure of its smoothness.
"A": Grease 99000-25010
6. Insert drive shaft joint or center drive shaft to differential gear. Install center bearing support with right side drive shaft
CAUTION:
^
Be careful not to scratch oil seal lip with drive shaft joint while inserting.
^
Make sure to insert drive shaft joint fully and seat its snap ring as it was.
^
Do not hit joint boot with hammer or the like. Nothing but hands is allowed to use when inserting joint.
Tightening Torque
(a): 50 Nm (5.0 kg-m, 36.0 ft. lbs.)
