SX4 4WD L4-2.0L (2008)
Keyless Start Control Module: Service and Repair
Keyless Start Control Module Removal and Installation
REMOVAL
1. Disconnect negative cable at battery.
2. Remove glove box from instrument panel.
3. Disconnect connector from keyless start control module.
4. Remove keyless start control module mounting bolt and then remove keyless start control module (1) from steering support member (2).
INSTALLATION
For installation, reverse removal procedure.
If keyless start control module is replaced, register ID code of remote controller into keyless start control module, referring to Registration Procedure for
Remote Controller ID Code.
