SX4 4WD L4-2.0L (2008)
3. Connect forward impact-sensor connector (4) by pushing connector till click is heard from it.
4. Install front bumper referring to Front Bumper and Rear Bumper Components.
5. Enable air bag system referring to Enabling Air Bag System:Except advanced Air Bag.
6. Connect negative (-) cable at battery.
Advanced Air Bag
Forward Impact-Sensor Removal and Installation
WARNING: During service procedures, be very careful when handling a sensor.
^
Never strike or jar a sensor.
^
A sensor and mounting bracket bolts must be carefully torqued to assure proper operation. Under loose connection, it could cause
improper operation of the air bag system.
REMOVAL
1. Disconnect negative (-) cable at battery.
2. Disable air bag system referring to Disabling Air Bag System:Advanced Air Bag.
3. Disconnect forward impact-sensor connector (1) sliding connector outer (2) as shown.
4. Remove forward impact-sensor bolts (3) and forward impact-sensor (4) from apron side member (5).