XL-7 2WD V6-3.6L (2007)
NOTE: The engine front cover is removed for clarity in the following graphics, but NOT required to perform the procedure.
11. Ensure that the feet (4) on the legs of the tool are facing the front of the engine.
12. Partially expand the legs (1, 3) of the EN-48313 by turning the T-shaped handle clockwise.
13. Insert the leg of the tool (1) behind the timing chain guide (2).
14. Continue expanding the EN-48313 until the legs (1, 3) contact the timing chain. Do not tighten at this time.
NOTE: Ensure that the foot (1) of the EN-48313 is engaged into one of the link pockets to prevent tool slippage during tightening of the
EN-48313.
15. Hand tighten the EN-48313.
CAUTION: Refer to [Torque Reaction Against Timing Drive Chain Notice].
16. Use an open end wrench on the hex cast into the left intake and exhaust camshafts and rotate the camshafts toward each other in order to create
slack in the chain between the actuators.
