XL-7 2WD V6-3.6L (2007)
Camshaft Gear/Sprocket: Service and Repair
Camshaft Position Actuator Replacement - Bank 2 (Left Side) Intake
Camshaft Position Actuator Replacement - Bank 2 (Left Side) Intake
Removal Procedure
1. Remove the left exhaust camshaft actuator.
2. Remove the intake camshaft position actuator bolt.
3. Remove the left intake camshaft position actuator.
Installation Procedure
1. Locate the intake camshaft position actuator to the camshaft and loosely install the bolt.
CAUTION: Refer to [Torque Reaction Against Timing Drive Chain Notice].
NOTE: Use the open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
2. Tighten the camshaft position actuator bolt.