XL-7 2WD V6-3.6L (2007)
Audible Warning Device: Testing and Inspection
Chime Malfunction
Chime Malfunction
Diagnostic Instructions
^
Perform the [Diagnostic System Check - Vehicle Diagnostic Information] prior to using this diagnostic procedure. See: Testing and
Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check - Vehicle Diagnostic Information
^
Review [Strategy Based Diagnosis] for an overview of the diagnostic approach. See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/Strategy Based Diagnosis
^
[Diagnostic Procedure Instructions - Vehicle Diagnostic Information] provides an overview of each diagnostic category. See: Testing and
Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions - Vehicle Diagnostic Information
Circuit/System Description
The radio generates the audible warning through the left speaker. The radio receives audible warning requests via the serial data circuit from the
instrument panel cluster (IPC) or the body control module (BCM).
Circuit/System Verification
NOTE: Before performing this diagnostics, make sure no indicators are illuminated after the IPC performs a lamp test. If any indicators are illuminated
after the bulb test, perform the indicator diagnostics before this diagnostics.
1. Ignition ON, headlamp switch OFF, verify the scan tool Headlamp Switch parameter is Inactive.
^
If not Inactive, refer to [Headlamps Malfunction].
2. Ignition ON, park lamp switch OFF, verify the scan tool Park Lamps Switch parameter is Inactive.
^
If not Inactive refer to [Park Lamps Malfunction].
3. Ignition ON, doors closed, verify the scan tool All Door Lock Command is On.
^
If not On, refer to [Courtesy Lamps Malfunction].
4. Ignition ON, radio ON, adjust the radio balance and fade to the left front speaker.
^
If the speaker does not operate properly, refer to [Speaker Malfunction].
5. Verify that the Key In Ignition Status parameter is Key In when the key is in the ignition and Key Out when the key is out of the ignition.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the ignition switch.
2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 3 and ground.
^
If the test lamp does not illuminate, test the B+ circuit for an open/high resistance. If the circuit tests normal and the power mode circuit fuse is
open, test the signal circuit terminal 5 for a short to ground.
3. Verify the scan tool Key In Ignition Status parameter is Key Out.
^
If not the specified value, test the signal circuit terminal 5 for a short to voltage. If the circuit tests normal, replace the BCM.
4. Install a 3 A fused jumper wire between the signal circuit terminal 5 and the B+ circuit terminal 3. Verify the scan tool Key in Ignition Status
parameter is Key In.
^
If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
5. If all circuits test normal, test or replace the ignition switch.
Repair Instructions
Perform the [Diagnostic Repair Verification - Vehicle Diagnostic Information] after completing the diagnostic procedure. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures
[Ignition and Start Switch Replacement]
