XL-7 2WD V6-3.6L (2007)
^
The seat belt pretensioner pigtail, if equipped, is damaged.
^
The seat belt retractor pretensioner connector is damaged.
^
The seat belt retractor pretensioner connector terminals are damaged.
Deployment and disposal of a malfunctioning seat belt pretensioner is subject to any required retention period.
WARNING: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint
seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal
injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat
belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws
Special Tool
J 38826 SIR Deployment Harness
J 38826 25 for seat belt pretensioner module adapter
J 39401-B SIR Deployment Fixture
An appropriate pigtail adaptor
1. Turn OFF the ignition.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove the seat belt retractor pretensioner from the vehicle. Refer to [Seat Belt Retractor Pretensioner Replacement - Front].
5. When carrying a seat belt retractor pretensioner to the deployment area, keep fingers clear of the seat belt webbing.
6. Clear a space on the ground about 1.85 m (6 ft) in diameter (a) for deployment of the seat belt pretensioner. If possible, use a paved, outdoor
location free of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
8. Place the J 39401-B in the center of the cleared area.
