XL-7 2WD V6-3.6L (2007)
4. Install the 4 rear support to body bolts.
Tightening torque
Tighten the rear support to body bolts to 170 Nm (125 ft. lbs.).
5. Install the coil springs.
6. Install the adjustment links.
7. Install the trailing arms.
8. While holding the stabilizer link, install the stabilizer link-to-lower control arm nut.
Tightening torque
Tighten the stabilizer link to lower control arm nut to 15 Nm (11 ft. lbs.).
CAUTION:
Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the
caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
9. Remove the supporting wire and position the brake caliper and bracket assemblies back onto the knuckles.
10. Install the rear brake hose bracket nut and bolt.
Tightening torque
Tighten the rear brake hose bolt and nut to 12 Nm (106 in. lbs.).
11. Position the wiring harness back to the original location, connect the routing clips to the rear support and upper control arms. Connect the rear
wheel speed sensor electrical connectors.
