XL-7 2WD V6-3.6L (2007)
CAUTION:
Refer to [Fastener Notice].
5. Tighten the bolts and nuts in the following sequence:
Tightening torque
^
Tighten the knuckle to lower control arm bolt and nut to 160 Nm (118 ft. lbs.).
^
Tighten the knuckle to upper control arm bolt and nut to 160 Nm (118 ft. lbs.).
^
Tighten the knuckle to toe link bolt and nut to 160 Nm (118 ft. lbs.).
^
Tighten the 3 trailing arm to knuckle bolts to 110 Nm (81 ft. lbs.).
6. Install the wheel bearing/hub assembly.
CAUTION:
Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the
caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
7. Remove the supporting wire and position the brake caliper and bracket assemblies back onto the knuckles.
8. Connect the rear park brake cable through the mounting bracket and onto the park brake actuator.
9. Install the tire and wheel.
10. Lower the vehicle.
11. Perform a vehicle wheel alignment.
