XL-7 2WD V6-3.6L (2007)
Suspension Strut / Shock Absorber: Overhaul
Strut, Strut Component and/or Spring Replacement
Special Tool
J 42991 Strut Rod Nut Socket
J 45400 Strut Spring Compressor
Removal Procedure
1. Install the strut assembly in the J 45400 using the following procedure.
a. Adjust the lower legs of the J 45400 to the lowest possible coil of the spring.
b. Adjust the upper legs of the J 45400 to the highest possible coil of the spring.
c. Inspect the strut assembly to insure hooks on the strut compress legs are properly installed on the spring coils.
d. Verify the strut assembly is parallel with the J 45400.
2. Compress the spring enough to unload the upper strut mount.
CAUTION:
Do not allow the absorber rod to rotate during disassembly/reassembly, Use hand tools to keep the absorber rod from rotating. If air tools
are used, and the rod is allowed to rotate, damage to the absorber may occur.
3. Use the J 42991 or equivalent hand tools to remove the strut shaft nut.
