XL-7 2WD V6-3.6L (2007)
3. Install the control valve body cover (1) onto the transaxle case.
NOTE:
Use LOCTITE 242 thread sealer on ALL bolt threads.
4. Install the control valve body cover bolts (2) hand tight.
CAUTION:
Refer to [Fastener Notice].
5. Tighten the control valve body cover bolts in the sequence shown.
Tightening torque
Tighten the bolts to 13 Nm (115 in. lbs.).
6. Install the transaxle oil cooler lines and seals to the transaxle.
7. Install the front engine mount.
8. Install the left and right splash shield.
9. Install the left front wheel and the tire assembly.
10. Lower the vehicle.
11. Check the transaxle fluid level.