XL-7 2WD V6-3.6L (2007)
Seals and Gaskets: Service and Repair
Drive Axle Shaft Seal Replacement (Right)
Drive Axle Shaft Seal Replacement (Right)
Special Tool
J 45000 Seal Remover
DT-48392 Differential Oil Seal Installer
J 8092 Driver Handle
Removal Procedure
1. Raise and support the vehicle.
2. Place a drain pan under the transaxle to catch any spilled transaxle fluid.
3. Remove the right front wheel drive shaft.
4. If equipped with an axle seal dust cover, discard it and do not replace it.
5. Using the J 45000 remove the right drive axle seal from the transaxle.
6. Clean the seal bore in the transaxle housing.
Installation Procedure
1. Using the DT-48392 with J 8092, install the right drive axle seal onto the transaxle.
2. Install the right front wheel drive shaft.
3. Lower the vehicle.
NOTE:
Dextron(R)III automatic transmission fluid is not compatible with this transaxle.
If Dextron(R)III ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid GM P/N 88900925. 1
4. Inspect the transaxle fluid level.