XL-7 2WD V6-3.6L (2007)
Installation Procedure
1. Position the transaxle mount in place between the frame and mount bracket (1).
2. Lower the transaxle onto the mount (3).
CAUTION:
Refer to [Fastener Notice]
3. Install the transaxle mount to bracket nuts (2).
Tightening torque
Tighten the nuts to 37 Nm (27 ft. lbs.).
4. Remove the transaxle mount to frame nuts (4).
Tightening torque
Tighten the nuts to 37 Nm (27 ft. lbs.).
5. Remove the transmission stand.
6. Lower the vehicle.
Transmission Rear Mount Bracket Replacement (FWD)
Transmission Rear Mount Bracket Replacement (FWD)
Removal Procedure
1. Remove both catalytic converters.
2. Remove the rear transaxle mount.