XL-7 2WD V6-3.6L (2007)
NOTE:
^
When cutting out the quarter window use care not to damage the encapsulation around the perimeter of the quarter window. If the
encapsulation is damaged, the window must be replaced.
^
Keep the cutting edge of the tool against the quarter window. Do this from inside the vehicle to protect the outer painted surface.
5. Remove the window from the urethane adhesive.
^
Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
^
The only suitable lubrication is clear water.
^
Use the J 24402-A, J 39032, or equivalent in order to remove the quarter window.
6. With the aid of an assistant, remove the window (1) from the vehicle.
Installation Procedure
NOTE: The molded encapsulation surrounding the quarter window is made using PVC plastic materials. Use a specific PVC primer application prior to
applying the urethane adhesive bead to the window.
1. Install the quarter window into the opening.
2. Install the rear quarter front applique.
3. Install the inside garnish molding.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
5. Close the liftgate.
