XL-7 Limited 4WD V6-2.7L (2002)
5. Remove rear wheel speed sensor from rear axle.
CAUTION:
-
Do not pull wire harness when removing rear wheel speed sensor.
-
Do not cause damage to surface of rear wheel speed sensor and do not allow dust, etc. to enter its installation hole,
Installation
1. Check that no foreign material is attached to sensor and rotor.
2. Install it by reversing removal procedure.
CAUTION: Do not pull wire harness or twist more than necessary when installing rear wheel speed sensor.
Tightening torque
Rear wheel speed sensor bolt (a): 21 Nm (2.1 kgf-m, 15.5 ft. lbs.)
3. Check that there is no clearance between sensor (1) and knuckle.
Inspection
