4 Runner 2WD L4-144.4 2366cc 2.4L SOHC (22R-E) (1990)
/Page-833001.png)
Input Shaft: Testing and Inspection
W46, W55, and W56 Transmissions
INSPECTION OF INPUT SHAFT ASSEMBLY
INSPECT SYNCHRONIZER RING
(a) Turn the ring and push it in to check the braking action.
(b) Measure the clearance between the synchronizer ring back and the gear spline end.
Standard clearance:
0.7 - 1.7 mm (0.028 - 0.067 in.)
Minimum clearance:
0.5 mm (0.020 in.)
If the clearance is less than the limit, replace the synchronizer ring.
