4 Runner 2WD L4-2.7L (2TR-FE) (2010)
Hood Shock / Support: Removal and Replacement
Components
DOOR / HATCH: HOOD SUPPORT: COMPONENTS
Removal
DOOR / HATCH: HOOD SUPPORT: REMOVAL
HINT
*
Use the same procedure for the RH and LH sides.
*
The procedure listed below is for the LH side.
1. REMOVE HOOD SUPPORT ASSEMBLY LH
NOTICE:
*
Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while
servicing the vehicle.
*
Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas
leaks.
*
In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.
(a) Using a screwdriver, remove the 2 stop rings as shown in the illustration, and then remove the hood support.
NOTICE:
Remove the hood support assembly while supporting the hood panel with one hand.
HINT
Tape the screwdriver tip before use.