4 Runner 2WD L4-2.7L (2TR-FE) (2010)
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO DLC3 (CANH, CANL)
OK -- Continue to next step.
3. CONNECT CONNECTOR
(a) Reconnect the F59 No. 2 junction connector connector.
NEXT -- Continue to next step.
4. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (NO. 1 JUNCTION CONNECTOR SIDE)
(a) Disconnect the A36 No. 1 junction connector connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CONNECT CONNECTOR
OK -- Continue to next step.
5. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (NO. 1 JUNCTION CONNECTOR - SKID CONTROL ECU)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance: