4 Runner 2WD L4-2.7L (2TR-FE) (2010)
Result
HINT
*: The Techstream cannot communicate with the ECM.
B -- GO TO VC OUTPUT CIRCUIT See: Testing and Inspection/Component Tests and General Diagnostics/VC Output Circuit
A -- Continue to next step.
6. CHECK COMBINATION METER ASSEMBLY
(a) Disconnect the ECM connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
OK -- REPLACE ECM See: Engine Control Module/Service and Repair/Removal
7. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
(a) Disconnect the combination meter connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(d) Reconnect the ECM connector.
(e) Reconnect the combination meter connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM)
OK -- REPLACE COMBINATION METER ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster
/ Carrier/Service and Repair/Removal and Replacement/Combination Meter/Removal