4 Runner 2WD L4-2.7L (2TR-FE) (2010)
Parking Brake Warning Switch: Service and Repair
Removal
PARKING BRAKE: PARKING BRAKE SWITCH: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Remove the lower No. 1 instrument panel airbag assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal
and Replacement/Knee Airbag Assembly (for Driver Side)/Removal.
3. REMOVE TURN SIGNAL FLASHER ASSEMBLY See: Lighting and Horns/Hazard Warning Lamps/Hazard Warning Flasher/Service and
Repair/Removal
4. REMOVE TIRE PRESSURE WARNING ECU See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure
Module/Service and Repair/Removal
5. DISCONNECT PARKING BRAKE CONTROL PEDAL ASSEMBLY
(a) Partially remove the front floor carpet.
(b) Remove the 2 nuts and disconnect the No. 1 parking brake cable assembly from the body.
(c) Disconnect the parking brake switch connector.
(d) Remove the 3 nuts and disconnect the parking brake control pedal assembly from the body.
6. REMOVE PARKING BRAKE SWITCH ASSEMBLY
(a) Remove the screw and parking brake switch assembly from the parking brake control pedal assembly.