4 Runner 2WD L4-2.7L (2TR-FE) (2010)
HINT
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
8. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH (w/o KDSS)
HINT
Use the same procedure described for the LH side.
9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH (w/o KDSS) See: Stabilizer Bar/Service and Repair/Front Stabilizer Bar (w/o
KDSS)/Removal
10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH (w/o KDSS) See: Stabilizer Bar/Service and Repair/Front Stabilizer Bar (w/o
KDSS)/Removal
11. REMOVE FRONT STABILIZER BAR (w/o KDSS)
12. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/ REAS)
NOTICE:
Perform this procedure with the vehicle jacked up so that all the shock absorbers are extended.
(a) As shown in the illustration, loosen the nut and disconnect the tube.
NOTICE:
Never loosen the absorber hoses or the flare nuts at the joint parts.
(b) Remove the bolt and bracket.
(c) Remove the bolt, nut and washer.
(d) Remove the 3 nuts on the top of the front shock absorber with coil spring.