4 Runner 2WD L4-2.7L (3RZ-FE) (1996)
Circuit Opening Relay: Testing and Inspection
1. REMOVE LOWER FINISH NO.1 PANEL
2. REMOVE CIRCUIT OPENING RELAY
3. INSPECT CIRCUIT OPENING RELAY
-
Using an ohmmeter, check that there is continuity between terminals 1 and 2.
-
If there is no continuity, replace the relay.
-
Check that there is no continuity between terminals 3 and 4.
-
If there is continuity, replace the relay.
-
Apply battery positive voltage across terminals 1 and 2.
-
Using an ohmmeter, check that there is continuity between terminals 3 and 4.
-
If operation is not as specified, replace the relay.
4. REINSTALL CIRCUIT OPENING RELAY
5. REINSTALL LOWER FINISH NO.1 PANEL