4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
(b) Remove the nut, and disconnect the generator wire and wire clip.
(c)
Remove the lock, pivot bolts and the generator.
(d) Remove the bolt and adjusting bar.
(e)
Remove the 3 bolts and generator bracket.
7. Remove crankshaft position sensor.
(a)
Remove the 2 bolts and crankshaft position sensor.
(b) Remove the O-ring from the crankshaft position sensor.
8. Remove flywheel housing under cover and dust seal.
9. Remove oil pan.
(a)
Remove the 16 bolts and 2 nuts.
(b) Insert the blade of Special Service Tool (SST) Oil Pan Seal Cutter # 09032 - 00100 or equivalent between the cylinder block and oil pan, cut
off applied sealer and remove the oil pan.
CAUTION: Be careful not to damage the oil pan flanges of the oil pan and cylinder block.
