4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
d. Remove the O-ring from the rack housing.
11. Remove the control valve assembly, doing the following.
a. Using the 09631-20060 SST, loosen the bearing guide nut.
b. Wind vinyl tape to the control valve shaft.
c. Using a plastic hammer, tap out the valve assembly with the nut from the control valve housing.
NOTE: Be careful not to damage the oil seal lip.
d. Remove the nut from the valve assembly.
NOTE: Be careful not to damage the oil seal lip.
e. Remove the O-ring from the nut.
12. Remove the cylinder end stopper, performing the following procedures.
a. Using the 09922 - 10010 SST, remove the stopper.
NOTE: Use SST 09922-10010 in the direction shown in the illustration.
b. Remove the O-ring from the stopper.
13. Remove the steering rack and oil seal by doing the following steps.
